Issue #1:
The first issue is for when the PC will not ever shut down and the yellow LED on the Startup/shutdown controller never turns off. This is fixed by updating a setting in the BIOS of the PC.
Solution #1:
To update your BIOS, you will need to follow the steps below.
Step 1: Power off the machine, open the backbox and make sure the PC is off.
Step 2: Connect a USB keyboard to your Gigabyte PC.
Step 3: Power on your PC using the power button on the PC case.
Step 4: Immediately push the delete key a few times to enter the BIOS. The screen will turn into a blue colored menu system.
Step 5: Scroll to the right until you are on the Chipset tab. You may need to remove your LCD display to see where you are in the BIOS menu.
Step 6: Update the setting called ERP Support to be enabled.
Step 7: Scroll to the right and select save and exit. The computer will reboot and the setting will be saved.
Step 8: Power off the PC
Step 9: Turn on game power switch and enjoy your Bride of Pinbot 2.0
Issue #2:
The computer not starting up properly from a cold boot. This is caused by the 5v on some machines is not quite high enough to trigger the startup controller properly. Currently, the CSSC cable from the P-ROC to the startup controller is providing 5vdc from the P-ROC.
Solution #2:
If your 5v is not strong enough and you are experiencing issues starting up, you can swap the pins on this cable to pull the 12v connection from the P-ROC on that same cable. Please only do this if you are experiencing an issue.
The picture below shows the pin-out pulling 12v from the P-ROC. You will need to pull the wire from pin 4 and insert it into pin 1.
If you have any other questions about these updates, please respond below or contact the support team by emailing support@dutchpinball.com.